A twin-roll cast material of Mg-9.0 mass%Al-0.72 mass%Zn-1.85 mass% Sn-0.21 mass%Mn (AZT912) with 2.4 mm thick and 100 mm width that was given pre-strain after solution heat treatment was tested by V-bending at room temperature.
The purpose of this study is to fabricate a thin sheet plate for the practical use of plastic forming in room temperature by using twin-roll cast Mg-9mass%Al-1...
In order to advance the development of innovative lightweight materials, it has been clarified the effects of heat treatment of magnesium alloys and silane coupling conditions on the bonding strength of the laminated Mg alloy/polymer material. Effects of silane coupling condition on bonding have been mainly discussed on laminated Mg alloy/polymer material.
It has been considered that the...
High performance alloys for Aerospace applications are cast in cylindrical copper crucibles. Maintaining the appropriate crucible taper and diameter is critical to a quality casting. The use of micrometers, feeler rods, visual inspection is popular for a quick assessment of crucible diameter and condition. In this work, a sensor is used to measure the crucible diameter, and video camera to...
Feeding steel strip into molten steel in the mold is an effective technique for refining the solidification structure of steel (especially high-alloy steel) during the continuous casting process. This study experimentally investigated the effects of feeding strip on the solidification structure of super austenitic stainless steel S32654 and clarified the relative mechanism by combining...
For low carbon content personalized steel grades, the corresponding relationship between the banded microstructure at the typical position of 1/4 width of hot rolled steel coil and the W shape of the solidification end point of the cast slab was revealed. The influence of hereditary laws such as casting solidification structure and element distribution on banded microstructure was clarified. ...
Large inclusions (size ≥ 100μm) deteriorated the cleanliness of AISI 431 stainless steel ingots fabricated by a Chinese steel mill, resulting in the formation of defects that can be visually observed on the surface of the oil pump. Here, we revealed the Al contents and inclusion evolution route in the process of “AOD refining - LF refining - Casting - Rolling” by analyzing samples obtained...